Alarm System for Mobile Units

Iris offers a complete solution by integrating the following elements:
• Main circuit
• Affiliate circuits that communicate by radio frequency
• Secure website to enter the necessary information

MAIN CIRCUIT :
The main circuit is composed of:br /> • A cellular modem to send SMS messages in case of an alarm, receive SMS messages to arm and disarm the system and to receive the configuration entered by the website.

• A radio circuit to communicate with affiliate circuits
• A battery charger to make it work in the event of a power failure
• Four 12 V inputs to monitor points that are very close
• Two outputs to operate a siren and to indicate that the system is active
The radio circuit operates with a mesh topology. Which means that if an affiliate device is too far to directly communicate with the main circuit, it will communicate its status to another device that is closer so that it retransmits to the main circuit.
The system is also protected against false requests. Only telephones programmed into the website can interact with the system. In addition, an access code is entered by telephone number, so you must have the right code with the right telephone to be able to interact with the system.
The system operates with the same voltage as conventional alarm systems, so devices available on the market can be used for detection.

AFFILIATE CIRCUITS
Affiliate circuits can extend surveillance over a large area without having to install wires between locations. For construction sites, one or two affiliate devices per floor can be installed to provide complete monitoring of the site without having to install wires. For marinas, each boat can be equipped with an affiliate device to monitor it.

WEBSITE
The website allows you to configure the alarm system to assign telephones that are authorized to interact with the system. It also allows you to assign names to the entries allowing for much more user-friendly alarm messages. Several other features can be easily programmed using the website.